Table of Contents
Advertisement
Using S-Video jack
IMPORTANT!
– If S-Video is used for DVD playback
connection, the system's COMPONENT
setting will need to be changed
accordingly.
1
Use an S-Video cable (not supplied) to connect
the DVD system's S-VIDEO jack to the S-
Video input jack (or labeled as Y/C or S-VHS) on
the TV.
2
To listen to the TV channels through this DVD
system, use the audio cables (white/red-not
supplied) to connect AUX IN L/R jacks to the
corresponding AUDIO OUT jacks on the TV.
Using an accessory RF modulator
IMPORTANT!
– If your TV only has a single Antenna In
jack (labeled as 75 ohm or RF In), you
will need an RF modulator in order to
view DVD playback on the TV. See your
electronics retailer or contact Philips for
details on RF modulator availability and
operations.
1
Use the composite video cable (yellow) to
connect the DVD system's VIDEO jack to the
video input jack on the RF modulator.
2
Use an RF coaxial cable (not supplied) to
connect ANTENNA OUT or TO TV jack on the
RF modulator to the Antenna IN jack on the TV.
3
Connect the Antenna or Cable TV service signal
to the ANTENNA IN or RF IN jack on the RF
modulator. (It may have been connected to your
TV previously. Disconnect it from the TV.)
Connections
11
Advertisement
Table of Contents
