Table of Contents
Advertisement
IMPORTANT!
– The type plate is located at the
bottom of the system.
– Before connecting the AC power cord
to the wall outlet, ensure that all
other connections have been made.
– Never make or change any
connections with the power switched on.
Step 1: Placing the speakers
Front
speaker
( left )
VIEWING AREA
●
Place the front left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
Notes:
– To avoid magnetic interference, do not position
the front speakers too close to your TV set.
– Allow adequate ventilation around the DVD
System.
Step 2: Connecting speakers
●
Connect the left and right speakers to the
SPEAKERS (4Ω) terminals on the back of the
system with the supplied speaker cables. Right
speaker to "R" and left speaker to "L", red wire
to "+" and silver wire to "-". Fully insert the
stripped portion of the speaker wire into the
terminal as shown.
Front
speaker
( right )
Speaker wire connection on main set
1
Speaker wire connection on speakers
Notes:
– Ensure that the speaker cables are correctly
connected. Improper connections may damage the
system due to short-circuit.
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker jacks.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Connections
2
1
2
3
9
Advertisement
Table of Contents
