Table of Contents
Advertisement
INSTALLER AND USER GUIDE FOR REVERSE OSMOSIS SYSTEM ECOSOFT ROBUST 1000, ROBUST 3000
4. INSTALLATION STEPS
Carefully read this manual before installing the reverse osmosis system.
4.1. INSTALLATION CONDITIONS AND PACKAGE COMPLETENESS CHECK
1) Check that all components of the reverse osmosis system (see section 2.3) are inside the package.
Do not open the plastic bag before you make sure it contains all parts. Missing part claims will not
be accepted if the package is broken.
2) Ensure that your utilities meet this product's requirements:
Inlet water pressure*
Test water pressure at the tapping point. It must
comply with the specification in section 2.1.
*If any of the parameters does not meet the requirement, consult section 2.1 for possible corrective
action.
— check other parameters of the technical specification (section 2.1);
— check that feed water meets requirements shown in section 2.2.
If the water quality does not meet requirements, refer to a water treatment specialist company
for assistance selecting the appropriate product for normalizing the offending constituents.
3) Before proceeding with the installation, ensure there is enough space for the assembled system.
If using pressure tank, provide room for it as well. In case of shortage of space, pressure tank can
be removed to the distance of connecting tube length.
4) Install the reverse osmosis system in accordance with below procedure.
4.2. INSTALLATION
CAUTION!
This product has been factory tested for leaks, and may contain residual moisture.
Before installation of tubing, filters, and membranes, wash your hands with antibacterial soap.
Ensure that the installation place is shielded from the direct sunlight and removed from heating
appliances.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2016
Influent water temperature*
Test water temperature and verify
compliance with specification in section 2.1.
38
Hide quick links:
Advertisement
Table of Contents
