Ecosoft ROBUST 1000 Installer And User Manual page 14

INSTALLER AND USER GUIDE FOR REVERSE OSMOSIS SYSTEM ECOSOFT ROBUST 1000, ROBUST 3000
11 Install carbon post-filter.
12 Install all membranes in membrane housings.
CAUTION! When installing reverse osmosis mem-
brane, do not take it out of the bag. Cut the bag at
the opposite end to membrane's brine seal, push the
membrane inside membrane housing. Do not touch
membrane surface at any time.
13 Open feed valve and purified water faucet for 30 minutes to rinse membranes and other
parts of the system. Do not open tank valve at this time. Close the purified water faucet and
check all connections for leaks.
CAUTION! Inspect the system for leaks every day for the first week after installation.
Continue to check periodically onward. When leaving for an extended while, shut off the
main valve to remove water supply to the system.
14 Open tank valve and let the system fill it. The system will switch off when the tank is full.
Open purified water faucet and discard the first tankful of purified water. When the tank is
drained empty, close the purified water faucet and let the system refill the tank. The water
can be used now.
* Skip steps 6 and 14 if installing a tankless system.
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2016
A (1 : 1)
A
41
A (1 : 1
A