Basic Operation; Lcd Interface - Tripp Lite SMART3000RM2UL Owner's Manual

Basic Operation

LCD Interface

3-Digit Display: This display is generally used to show values for a given
"Display" or "Control" screen.
"ON/OFF" Button
• To turn the UPS ON: After you plug the UPS into a live AC outlet, the UPS (in
• To cold-start the UPS: If utility power is absent, you can "cold-start" the UPS
• To turn the UPS OFF: With the UPS ON and receiving utility power, press and
* If the user unintentionally presses the ON/OFF button, the OFF function can be
"MODE" Button
To enable viewing of power displays and control menu options, tap this button.
See "Display Power Conditions" & "Control Menu Options" for details.
• Can be used in conjunction with the ON/OFF button to cancel the "OFF"
• Can be used in conjunction with the ENTER/MUTE button to restore the LCD
18-02-242-93378D.indb 10
"Standby" mode) will automatically charge its batteries, but will not supply
power to its outlets until it is turned ON. With the UPS plugged into a live AC
wall outlet, press and hold the "ON/OFF" button for one second.* The UPS
will beep once to indicate ON status. Release the button.
(i.e.: turn it ON and supply power for a limited time from its batteries) by
pressing and holding the "ON/OFF" button for one second.* The UPS will beep
once to indicate ON status. Release the button.
hold the "ON/OFF" button for 2.5 seconds.* The UPS will beep once to
indicate OFF status. Then unplug the UPS from the wall outlet. The UPS will
be completely OFF.
temporarily canceled by continuing to hold the ON/OFF button until the UPS beeps and
then momentarily pressing either the MODE button or the ENTER/MUTE button. Once
both buttons are released, the UPS will remain ON.
function. See "ON/OFF Button" instructions above.
to Factory Mode. See "Control Menu Options".
Note: This LCD image is shown
with all icons illuminated. Under
normal conditions, only select
icons will be lit.
10
6/11/2018 3:36:52 PM