Tripp Lite SMART3000RM2UL Owner's Manual page 17

Basic Operation
continued
Other UPS Features (Rear Panel)
AC Outlets: All models include NEMA 5-20R and NEMA L5-30R outlets. These
outlets provide your connected equipment with AC line power during normal
operation and battery power during blackouts and brownouts. The UPS protects
equipment connected to these outlets against damaging surges and line noise.
If you have a serial or USB connection to your UPS, you can remotely reboot
connected equipment by turning the outlets OFF and ON using Tripp Lite's
20A 120V
PowerAlert Software. The outlets are divided into one or more load banks
NEMA 5-20R
(labelled "LOAD 1," etc.) which may be remotely switched OFF and ON without
interrupting power to equipment connected to the other outlets. Outlets labelled
"UNSWITCHED" may not be remotely switched off.
30A 120V
NEMA L5-30R
Communications Ports (USB or RS-232): These ports connect your UPS to
any workstation or server. Use with Tripp Lite's PowerAlert Software and included
cables to enable your computer to automatically save open files and shut down
equipment during a blackout. Also use PowerAlert Software to monitor a wide
variety of AC line power and UPS operating conditions. Consult your PowerAlert
Software manual or contact Tripp Lite Customer Support for more information.
See "USB and RS-232 Serial Communications" in the "Optional Installation"
section for installation instructions.
EPO (Emergency Power Off) Port: Your UPS features a EPO port that may be
used to connect the UPS to a contact closure switch to enable emergency
inverter shutdown. See Optional Installation.
Accessory Slot: Remove the small cover panel from this slot to install optional
accessories to remotely monitor and control your UPS. Refer to your accessory's
manual for installation instructions. Contact Tripp Lite Customer Support at
www.tripplite.com/support for more information, including a list of available
SNMP , network management and connectivity products.
Output Breaker: Your UPS features one or more breakers that protect your UPS
from output overload. If one or more breakers trip, remove some of the load on
the circuit(s), then reset them by pressing the breaker switch(es) in.
Ground Screw: Use this to connect any equipment that requires a chassis
ground.
17
18-02-242-93378D.indb 17 6/11/2018 3:36:55 PM