Pair; Pair Again To Base; Pair To Mobile Device; Pair Mode - Plantronics Voyager 4210 Office User Manual

Pair

Pair again to base

Pair to mobile device

Pair mode

Your headset comes pre-paired to the base. To pair again:
Slide and hold the headset Power
1
blue.
Put your base into pair mode by pressing and holding the Bluetooth pairing button on the back
2
of your base for 2 seconds until the display panel's Bluetooth icon flashes blue and red.
Pairing is successful when you hear "pairing successful" and "base connected" and the display
panel's Bluetooth icon turns solid blue.
NOTE
Your headset can pair with up to 8 devices but only maintain 2 connections simultaneously;
this includes the base.
To put your headset in pair mode, slide and hold the Power
1
until you hear "pairing" and the headset LEDs flash red and blue.
Activate Bluetooth on your phone and set it to search for new devices.
2
• iPhone Settings > Bluetooth > On*
• Android Settings > Bluetooth: On > Scan for devices*
NOTE
*Menus may vary by device.
Select "PLT V4210 Series / PLT V4220 Series."
3
If necessary, enter four zeros (0000) for the passcode or accept the connection.
Once successfully paired, you hear "pairing successful" and the headset LEDs stop flashing.
NOTE
Your headset can pair with up to 8 devices but only maintain 2 connections simultaneously;
this includes the base.
Slide and hold the headset Power
blue.
switch away from the off position until the LEDs flash red and
switch away from the off position
switch away from the off position until the LEDs flash red and
8