FINAL ASSEMBLY
Congratulations! You have made it through, your TIMBER is ready to work! Just add the k nobs and
set the j umpers as you want (see the photo and manual). Before you connect anything, make sure
that your system is disconnected from power. Also double check the polarity of the ribbon cable, the
red cable should match the -12V rail both on the module and on the bus board!
TROUBLESHOOTING
If you have any issues with the module, please check the
F .A.Q.
at our website first. You can also
reach us here:
. Or send the module straight back to us using our
d iy@bastl-instruments.com
C ome to
Daddy
service.
29