Table of Contents
Advertisement
6) Place the f ront panel on the top board and mount the jacks.
7) Mount the spacer with the other one. Check the position of all the parts if they are flat on the
board and at the right angle and do the soldering ( S OLDERING TIP : you can start by
soldering just one of the leg at each component so you can make adjustments easier by
reheating)
CLEANING (OPTIONAL)
After the soldering is done you might want to c lean your PCB. You can use e.g. isopropyl alcohol. Put
some of the liquid all over the PCB using the brush (be aware to not let it flow into the pots), let it act
for a while and sweep it off. Then just let it dry. You can repeat these steps until you are satisfied with
the result.
28
Advertisement
Table of Contents
