Table of Contents
Advertisement
FINAL ASSEMBLY
Congratulations! You have made it through. Now just put the boards back together, put the f aceplate
on (secured by the screw and nuts with washers) and your KOMPAS is ready to work! Oh and don't
forget to put the k nobs and j umpers on (the l ed0 , l ed1 , l ed2 positions; 4th jumper must be left
unconnected for default operation - see picture).
Before you connect anything, make sure that your system is disconnected from power. Also double
check the polarity of the ribbon cable, the red cable should match the -12V rail both on the module
and on the bus board!
TROUBLESHOOTING
If you have any issues with the module, please check the
F .A.Q.
at our website first. You can reach us
here:
d iy@bastl-instruments.com
. We also provide service for the DIY stuff called Come to Daddy
(available at
h ttps://noise.kitchen
) .
17
Advertisement
Table of Contents
