Table of Contents
Advertisement
JACK CONNECTORS, POTENTIOMETERS & SWITCHES
You are almost done. Let's do the rest of the components by just putting them in first ( n o soldering
yet! - It starts at point 7! ) :
1) Unmount the top board.
2) Mount the spacer to the f ront p anel .
3) Check the set of p otentiometers now. There are five of them of four kinds (see the picture
below).
a) First, check the c enter detent ones (2x) and place them at their spot on the board
(the longer one goes to the bottom line).
b) The other taller one goes also to the bottom line on the right. The last two ones goes
to the spots that left. Be sure that the pots are placed in the right angle and they are
right on the board.
25
Advertisement
Table of Contents
