Basic Operation; Radio Reception; Selecting A Different Track; Playing A Cd - Philips DC1010/05 User Manual

Basic Operation/Radio

Basic operation

1 To select your sound source, adjust the
source selector to: TUNER, AUX, CD,
iPod, or OFF.
2 To switch off the set, adjust the source
selector to OFF position and check the
cassette keys are released.
Helpful hints:
In tuner mode, if you connect a 3.5 mm aux-in
cable, the source changes to AUX automati-
cally.
Adjusting volume
Adjust the volume with the VOLUME
control.

Radio reception

1 Adjust the source selector to TUNER.
2 Adjust BAND to FM or MW as your
desired band.
3 Turn TUNING to tune to a station.
• For FM, extend and turn the telescopic
antenna for best reception. Reduce its length
if the signal is too strong.
• For MW, the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
4 To switch off the radio, adjust the source
selector to OFF position.

Playing a CD

This CD player plays Audio Discs including
CD-Recordables and CD-Rewritable.
• MP3 CD-ROMs, CD-I, CDV,VCD, DVD or
computer CDs are not possible for playback
on this set.
IMPORTANT!
CDs encoded with copyright protection
•
technologies by some record companies may
be unplayable by this product.
1 Adjust the source selector to CD.
2 Open the disc door.
3 Insert a CD with the printed side facing up
and press the CD door gently to close.
➜ Display shows -- and later, the total
number of tracks. (See 2, 3)
4 Press 2; on the set to start playback.
➜Display: 2 and the current track number.
(See 4)
5 To pause playback press 2;. To resume
playback, press 2; again.
6 To stop CD play, press 9.
Helpful hints:
CD play will also stop when:
– you open the CD compartment;
– you select TUNER, AUX, or OFF sound
source;
– the CD has reached the end of playback.

Selecting a different track

• Press 5 or 6 once or repeatedly until the
desired track number appears in the display.
• In the stop/pause position, press 2; to start
playback.
CD Player