Table of Contents
Advertisement
Page 32 of 64
Attendant console operation
QMT2 feature enabled
Meridian 1 Attendant PC configuration
Figure 4
Meridian 1 Attendant PC Unit
brandline
insert
Status LED
553-2201-117 Standard 10.00 January 2002
When the QMT2 feature is enabled, the following conditions apply:
•
If the console is not in Shift mode, the keys in strip AK and/or BK
function as Incoming Call Identification (ICI) keys.
•
If the console is in Shift mode, the keys in keystrips AK and BK function
as Trunk Group Busy (TGB) keys. That is, they imitate the keystrips of
the QMT2 add-on module as follows:
— The LCD indicators pointing to the left indicate busy trunks.
— The LCD indicators pointing to the right indicate incoming calls.
The Meridian 1 Attendant PC Software application operates with the
Attendant PC Unit. See Figure 4 on page 32. The Attendant PC Unit is
typically installed under the attendant's PC monitor, and provides connection
to the Meridian 1 MDF and PC communications port. The Attendant PC Unit
hardware allows the software to communicate with the Meridian 1 and
simulate M2250 operation through a Windows 95® operating system
environment. The Attendant PC Unit is configured in LD 12. Refer to
Administration (553-3001-311) for configuration information.
alerter speaker
To install the Meridian 1 Attendant PC Software, an MPC 2-compliant PC
compatible Pentium system is required, with the following:
•
minimum 16 MB RAM
headset/handset
volume control
Hide quick links:
Advertisement
Table of Contents
