Allied Telesis AR Series Hardware Reference Manual page 88

88
Figure 57: Location of PAC slot and pillar mounts on an AR740 base board.
RJ45 RJ45
Clr Err D Act
Sec Sys Run Pwr
PORT 0 PORT 1 STATUS LEDs
SLIDE-IN BAY 0
PIC BAY 0
MAC CARD SLOT
LITHIUM BATTERY
DO NOT
DISPOSE IN FIRE
RUN CLEAR
POWER SYSTEM
LNK/ LNK/ Swap Hot
ACT ACT In Swap
100 100 Use Button
ETHERNET 0 ETHERNET 1
SLIDE-IN BAY 1
PIC BAY 1
SECURITY
6. Insert the PAC.
Position the PAC over the PAC slot on the router base card, making sure
that the support pillars located on the router base card are aligned with the
holes provided on the PAC. This ensures that the connector on the PAC is
correctly aligned with the slot on the router base card.
Press the connector firmly into place. Secure the PAC to its three pillars
using the fasteners supplied.
Figure 57 on page 88 shows the PAC slot on an AR740 base board.
7. Replace the router's lid and the power cord.
Secure the router's lid. If you disconnected an RPS supply, reconnect it
now.
8. If you disconnected interface cables to install the PAC, reconnect them.
The PAC is now ready to test.
NSM BAY
NSM CONNECTOR
THREAD MOUNTS FOR PAC PILLARS
AR Router
-12V
0V
0V
0V
+5V
+5V
+12V
-12V
0V
0V
+5V
+5V
+12V
740CPU
C613-03031-01 REV C