Programming Regeneration Cycles Time - Pentair FLECK 2910 NXT Installer Manual

Hide thumbs Also See for FLECK 2910 NXT:
Table of Contents

Advertisement

Installer manual Fleck 2910 NXT/NXT2 - Programming
1. Enable lock window with
ð Default setting: off;
2. Press
to validate the selection and advance to the next
parameter.
3. Set lock start time with
4. Press
to validate the selection and advance to the next
parameter;
5. Set lock end time with
6. Press
to validate the selection and advance to the next
parameter.

6.2.5.25 Programming regeneration cycles time

Set the regeneration cycles duration in minutes.
Info
A maximum of 5 cycles can be programmed.
For filter system only backwash and rapid rinse are available.
The sequence of the regeneration cycles depends upon regenerant flow, see System
regeneration cycle [}Page 21].
1. Adjust the cycle time with
ð Can be adjusted from: 0 to 240 minutes;
2. Press
to validate the selection and advance to the next
parameter;
3. Repeat for each cycle.
108 / 172
and
;
and
;
and
;
and
;
Lock window #2 activated.
Lock window #2 starts at
13:00.
Lock window #2 ends at
14:00.
1. Backwash: 10 min.
2. Draw: 60 min.
3. Rapid rinse: 10 min.
4. Tank Refill: 12 min.
5. Pause: not used.
Ref. MKT-IM-002 / E - 12.11.2019

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fleck 2910 nxt2

Table of Contents