User Programming - Pentair FLECK NXT Owner's Manual

SETTING TIME OF DAY AND
INITIATING A MANUAL
REGENERATION
Setting the Time of Day
1. Press and hold either the Up or Down button for
two seconds.
2. Press the Shift button to select the digit you want to
modify.
3. Press the Up or Down button to adjust the value.
4. Press the Extra Cycle button to return to the normal
display screen, or wait for a five second timeout.
Queueing a Regeneration
1. Press the Extra Cycle button. The Display Screen
will show "RGQ" as the valve status, indicating that
a regeneration is scheduled..
2. To cancel a queued regeneration, press the Extra
Cycle button.
Regenerating Immediately
Press and hold the Extra Cycle button for five seconds.

USER PROGRAMMING

WARNING:
Before entering User Programming,
please contact your local water treatment
professional. For complete programming options,
refer to Master Programming Flow Chart.
Enter User Mode
• Press and hold the Up or Down buttons for 5
seconds.
Set Language Option
• Press Up or Down to select language.
• Press the Extra Cycle button to proceed to the
next step.
Set Feed Water Hardness
Press the Shift, Up, and Down buttons to move the
cursor and change the value of the numbers.
Press the Extra Cycle button to proceed to the next
step.
NOTE: Only displayed when a metered option is
chosen under System Type.
Set Regeneration Day Override
• To turn On and set the days, press the Down
button.
• Press the Shift, Up, and Down buttons to move
the cursor and change the value of the numbers.
• Press the Extra Cycle button to proceed to the
next step.
Regeneration Time
• Press the Shift, Up, and Down buttons to move
the cursor and change the value of the numbers.
• Press the Extra Cycle button to end user
programming mode.
4 • Fleck NXT Owner's Manual
Figure 1 Up and Down Buttons
Figure 2 Shift Button
Figure 3 Extra Cycle Button
Figure 4 Select Language Screen
Figure 5 Feed Water Hardness Screen
Figure 6 Regeneration Day Override Screen
Figure 7 Regeneration Time Screen