ABB ACS880 P940 Series Supplement Manual page 46

46 Electrical installation
7. Connect the phase conductors of the input cable to the L1, L2 and L3 terminals and the
phase conductors of the motor cable to the T1/U, T2/V and T3/W terminals. Connect
the brake resistor conductors (if present) to the R+ and R- terminals. Tighten the screws
to the torque given in the figure below.
L1, L2, L3, T1/U, T2/V, T3/W, R-, R+/UDC+, UDC
R4
R5
8. Reinstall the shroud on the power terminals.
9. Go to section Connecting the control cables – ACS880-01 frames R4 and R5 (page
7 7
5 5
6 6
3.3 N·m
5.6 N·m
7
5
6
Grounding
2.9 N·m
2.9 N·m
8
47).