MSA FireHawk M7 Responder Operation And Instructions Manual page 3

Follow instruction in the "Preparing the Respirator for
Use" section before inserting or removing the mouth-
bit in the nosecup. Failure to follow this warning can
result in serious personal injury or death.
The nosecup must be installed when using the
FireHawk M7 Responder Air Mask. Failure to follow
this warning can result in serious personal injury or
death.
7. For more information on the air mask use and perfor-
mance standards, refer to the following publications:
NFPA Standard 1500, Fire Department Occupational
Safety and Health Programs (Chapter 5) and NFPA
1981 Standard, on Open-Circuit SCBA's for Fire
Service. Above publications are available from the
following: National Fire Protection Association,
Batterymarch Park, Quincy, MA 22269.
ANSI Standard Z88.5, Practices for Respiratory
Protection for the Fire Service; and, ANSI Standard
Z88.2, Practices for Respiratory Protection.
American National Standards Institute, 1430
Broadway, New York, NY 10018.
OSHA Safety and Health Standards (29 CFR 1910)
(see specifically Part 1910. 134), available from the
Superintendent of Documents, U. S. Government
Printing Office, Washington, DC 20402.
Compressed Gas Association, Inc., 1725 Jefferson
Davis Hwy., Suite 1004, Arlington, VA 22202.
INTRODUCTION
Note: The FireHawk M7 Responder HUD, FireHawk M7
Control Module, and FireHawk M7 Power Module have
been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radi-
ate radio frequency and, if not installed in accordance
with instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause interference to radio or television
reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and
the receiver
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV techni-
cian for help.
The FireHawk M7 Responder HUD, FireHawk M7
Control Module, and FireHawk M7 Power Module con-
tain electrical parts which have not been evaluated as
an ignition source in flammable or explosive atmos-
pheres by MSHA/NIOSH.
3 TAL 803 (L) Rev. 1 - 10086011