Intex ECO15230-2 Owner's Manual page 19

220-230 v, 50 hz, 300 w/520 w, hmax 5 m hmin 0.19 m ipx4 max. water temperature 35 degrees c
Table of Contents

Advertisement

OPERATING INSTRUCTIONS (continued)
To view the TIMER preset hours:
While the pump is operating, press
10 seconds and then display back the remaining operating hours.
To operate the sand filter pump manually (without the "TIMER"
mode):
1. To run the pump alone without the "Timer", press
on the pump, then press
this indicates that the TIMER is off and the pump is now operating
continuously.
2. To stop the pump, press
Set operating hours for
1.
Press
button to unlock the keypad.
With LED
flashing,
press
set the desired operating hours. See the
"Operating Time Table" for the required
operating hours related to each pool size.
Pressing
will
increase the time from
00
to 12 hours maximum. If you have
selected too many hours keep
activate your chlorinator, at the same time each day, for the number of hours you have set.
2.
With the desired hour value showing, press
chlorinator indicator light is up when activated. The system is now starting chlorine sanitizer
production and will stop after the operating hours are completed.
NOTE: If you forget to lock the keypad controls, the system will automatically lock it and start
working
10 seconds
later.
3.
The system in chlorinator mode will activate the pump automatically, the LED will always
first display the remaining chlorinator hours until it's finished.
hours, you
need to unlock the keypad and press
4.
To stop the chlorinator, press
button and reset the hour to
NOTE: If the chlorinator and the filter pump are in timer mode and the chlorinator timer is set
longer than the filter pump timer, the filter pump timer will automatically change to the same
time as the chlorinator set time.
SAVE THESE INSTRUCTIONS
(345IO) SAND FILTER PUMP COMBO ENGLISH 7.5" X 10.3" PANTONE 295U 07/10/2019
button, the display will briefly flash the preset hours for
button until the LED
button again.
the
Chlorinator:
button
to
pressing
to
button to unlock the keypad controls, then press
"00".
button to turn
displays
"FP",
(0 to 12 hours max per cycle)
repeat the cycle. The built-in timer will now
button to lock the keypad controls. The
To check the preset chlorinator
button.
English
345A
Page 19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eco20230-2Eco15220-2Eco20220-2

Table of Contents