GEV LightBoy 001244 Montage page 7

1. Mounting
1a
1b
The movement-detec-
tor reacts to heat. In
order to avoid false
switching,
mount the equipment
over radiators, etc., or
where the movement-
detector will be subjec-
ted to direct sunlight.
Mounting should only be
done by a specialist.
The work must only be
done when the equip-
ment has been discon-
nected from the electri-
city supply; also be sure
to switch off the electri-
city supply circuit
at the fuse box.
do not
Firstly, separate the frame and sensor. Then screw together accor-
1c
ding to the switch illustration shown below (figures 1 – 3). Insert the
supply unit into the recessed socket and tighten the fixing claws left
and right. Put the sensor unit on top and fix it by screwing to the
supply unit. The covering frame is easily placed into
position.
1 2
Replacement of a switch
Constant switching readiness:
additional switching-on by
hand is possible (hold down
Neutral wire required
the opener-pushbutton for
at least 1 sec.)
fixing claws
fuse
3
Parallel connection with 2 flush
mounted movement sensors