Ego Power+ LM2000 Operating Manual page 43

REPLACING THE WHEELS (Fig. 33a, 33b & 33c)
WARNING: Always remove the battery pack when servicing
or transporting the mower.
1. Turn the mower on its side with the upper surface against
a wall.
2. Use a flat blade screwdriver to pry the dust cover away
from the wheel.
3. Use an adjustable or 1/2 inch (13mm) wrench to turn the
bolt counterclockwise to loosen it.
4. Remove the bolt, the worn wheel and the wave washer
from the wheel axle.
Note: When replacing the rear wheel for the self propelled
mower (LM2100SP), remove the drive gear from the worn wheel
and assemble to the new wheel with the 3 screws.
5. Mount the wave washer and the new wheel on the wheel
axle. Note that the round recess must face outward.
6. Lock the wheel with the bolt by tightening the bolt clockwise.
7. Mount the dust cover onto the wheel and press it in place.
33b
30
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP & LM2100
Dust Cover
Bolt
Gear
Screw
Wave Washer
Wheel Axle
Rear wheel for LM2100SP
33a
Front wheel for both LM2100 & LM2100SP
33c
Round Recess
facing outside
Front Wheel
Dust Cover
Bolt
Wave Washer
Wheel Axle
Dust Cover
Bolt
Wave Washer
Wheel Axle
Rear wheel for LM2100
Round Recess
facing outside
Front Wheel
Round Recess
facing outside
Rear Wheel