Cleaning & Care - Cayin CDT-17A Operation Manual

Do not place anything heavy on the unit.
When the unit is moved:
Be careful not to drop the unit or subject it to strong shocks.
Make sure that the unit is disconnected from all connection cord.
For a distant transport, wrap it in the original package to prevent it from
scratch.
Keep the unit away from volatile substances. Do not keep the unit touching
rubber or vinyl material for a long period of time.
These materials may cause discoloration and surface damage to the unit.
Formation of Condensation inside the Unit
Condensation may form in the unit if:
The unit is in a room where the heater has just been turned on.
The unit is in a room with steam or high humidity.
The unit is brought from cold surroundings into a well-heated room.
When condensation has formed inside the unit, place the unit in a dry surrounding
for several hours before using.
Cleaning Care
Wipe the body and front panel of the unit with a soft, clean cloth.
If you use a chemically treated cloth for cleaning, refer to its notes on use.
For persistent stains, use a soft cloth moistened with mild detergent and water,
and then wipe with a dry cloth.
Notes for Disc
Never use cracked or warped discs.
Since the disc rotates at a high speed, use of cracked or warped ones will damage
the unit.
If a strange noise or vibration be heard or occur after starting playback,
immediately press the Open/Close (or
Maintenance
To clean a disc soiled with fingerprints or dust, use a soft and dry cloth.
If the surface is extremely dirty, dip a soft cloth into water and wring the cloth
well before wiping the disc. Then wipe again with a soft and dry cloth.
When wiping discs, always move the cloth from the center hole toward the outer
edge.
Do not use benzene, thinner, or a record cleaner.
Notes for Remote Control Unit
Before using the Remote Control Unit, it's necessary to install two
batteries.
Do not use rechargeable batteries.
Do not mix new and old batteries, or different brands of batteries.
Remove batteries when this unit is not in use for a long period of time.
Point the Remote Control Unit at the Remote Sensor on the front panel within
about 6 m and within about 30 .
Stop Open / ) Button to stop the disc rotation.
4
AAA (R03)