Connection Diagram - Cayin CDT-17A Operation Manual

III

CONNECTION DIAGRAM

Note: Y ou need wait for about 30 seconds after turning on the power every once because
the vacuum tubes need preheat.
Please make sure the following preparations are well done before using:
AC Power
1. Before connecting, make sure the power mark on the real panel is same to the
power voltage of your area.
2. Be sure the Power Switch on the front panel of the CDT-17A is tuned off (in the
out position).
3.Using the Power Cord (supplied), connect the Power Inlet on the CDT-17A's real
panel to the AC Power Outlet.
4. Press the Power Switch in. The Display will light up, indicating that the CD Player
is turned on.
5. To turn the CD Player off, press the Power Switch again and return it to the
position.
Unplug your CD player when it is not in use for a long period of time.
If you are using a switched outlet to turn on and off your CD Player, you should
leave the Power Switch in the
unit, it will power up in fully active mode.
Connections
1.Analog Outputs(unbalance).
A pair of standard RCA jacks supplies an analog output signal from the CDT-17A
to the source inputs of an audio amplifier or other components. Using the audio cable
R L SIGNAL INPUT
BAL INPUT
CD DVD TUNER
PUSH PUSH
2 1 2 1
3 3
MODEL S200
SER. NO:
~230V 50/60Hz 750W
RIGHT OUTPUT
+ -
SPARK ELECTRONIC EQUIPMENT CO., LTD.
DIGITAL INPUT
COAXIAL OPTICAL
BALANCE AES/EBU
UNBALANCE
RIGHT LEFT
RIGHT LEFT
ANALOG OUTPUT DIGITAL OUTPUT
on position. When AC Power is applied to the
2
TAPE R L
BAL OUTPUT
TAPE AUX OUT
L
R
CAUTION
RISK OF ELECTRIC
SHOCK DO NOT OPEN
LEFT OUTPUT
- +
POWER
ON
OFF
The radiators will be heated up when
FUSE T8A250V
the unit is working, please be careful
in order to avoid hurting to you.
ANALOG OUTPUT
MODEL
SER. NO:
L
NOTE: 1. Be sure to use at rated voltage.
2. Don't confuse L with R of ANALOG
OUTPUT when connecting.
R
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AC INPUT
~230V 50/60Hz 40W
COAXIAL MODEL: CDT-17A
SER. NO.:
OPTICAL
FUSE T1AL250V
SPARK ELECTRONIC EQUIPMENT CO., LTD. CAUTION
RISK OF ELECTRIC
SHOCK DO NOT OPEN
AMPLIFIER
/
D A PROCESSOR
~230V 50/60Hz
F1.5A250V
-
CDT 17A
out