Geca Tecno Control Unico Programming Instructions And Installation Manual page 11

carried out in "programming modalities", indicated on the display
with "prog". To enter in this modalities press the sliding key (
to exit and save automatically the changes do not press any key for
20 seconds.
If during the operations you keep inactive the chronothermostat until
when the notice "prog" is disappeared, before to proceed with pro-
gramming it will be necessary to press one again the sliding key (
Pressing the sliding key (
when the lighting messenger is positioned on the desired segment
you can program the temperature pressing key "T1
In this way it is possible to program the intervals time where you
wish comfort temperature (T2
perature (T1
day, you can program all the other in two different ways:
-Copy the day just programmed into the following one using the
"COPY" function (°C/h and DAY keys together);
-Move into the day after pressing DAY key ; in this case it will be
showed the program in memory or , if there is not , it will be showed
the standard program.
In each case it is always possible to make other changes using as
decribed above the keys "
SETTING OF T1 AND T2
T1 (economy temperature) and T2 (comfort temperature) are easy
to program by means of the two knobs on the front of the chronother-
mostat; for a better regulation proceed in the following way :
- Be sure to not be in programming modality , on the contrary wait
until "prog" is cancelled;
- Press the key T1 or T2 correspondent to the temperature to be pro-
grammed, and the sector corresponding T1 or T2 will lighting on the
display, and there will be indicated the programmed temperature;
- Regulate the temperature by the relevant knob (T1 or T2) control-
ling the value on the display.
After 5 seconds of inactivity the chronothermostat will come back to
the normal conditions.
) in the day of Monday. After programming the first
) you can slide the daily program and,
) and those with economy tem-
", " T1 " and " T2
),
).
" or "T2 ".
".