Stihl KB-MM Instruction Manual page 12

English
NOTICE
It must not be possible to rotate the
gearbox on the drive tube.
Mounting the MultiTool
1 2
Push the grass shield (1) onto the
N
axle (2) as far as stop.
3
2
Push the axle (2) onto the drive
N
shaft (3) as far as stop.
Insert and engage the pin (4) in the
N
axle and through the drive shaft.
10
Installing the Bristle Brush
2
Push the bristle brush (5) onto the
N
axle (2) .
Insert the hitch pin (6) in the hole at
N
the end of the axle and fold it flat.
Use the same procedure to mount
N
the other bristle brush.
WARNING
4
Always mount both bristle brushes.
Installing the PowerSweep
2
Push the sweeper drum (5) onto the
N
axle (2) – as shown .
Insert the hitch pin (6) in the hole at
N
the end of the axle and fold it flat.
Use the same procedure to mount
N
the other sweeper drum.
Always mount both sweeper drums.
Deflector Extensions
5
6
Deflector extensions come standard
with the bristle brush and are available
as special accessories for the
PowerSweep.
The left and right deflector extensions
are different.
Mounting the Deflector Extensions
N
5
N
6
Removing the Deflector Extensions
N
WARNING
1 1
Slide the right-hand extension onto
the deflector, push it fully home at
the top and bottom and engage the
tab (1).
Slide the left-hand extension onto
the deflector, push it fully home at
the top and bottom and engage the
tab (1).
Use the combination wrench to
disengage the tabs (1) and then pull
off the extensions.
KB-MM, KW-MM