Page 1
Installation Kit, Bead Dispenser LineLazer 3400 Airlessco 3350, 3350 , 4350 3A5205A Pioneer 3500, 3500 For application of line striping materials. Not approved for use in European explosive atmosphere locations. Important Safety Instructions Read all warnings and instructions in this manual and related manuals.
Page 2
Bead Dispenser Kit Bead Dispenser Kit Setup 8. Move bead dispenser to desired location on rod. Loosen screw (4) and position link (3) to connect to gun trigger actuator (C). Tighten screw (4) and attach dispenser connecting rod (B) to gun trigger with bridge pin (2).
Bead Dispenser Kit Dispenser Adjustments Only use dry, clean beads. Any moisture or contamina- tion with beads will cause poor bead flow. A window type screen can be used to remove unwanted debris Adjust dispenser plates up or down for desired bead before filling glass bead hopper.
Page 5
Bead Dispenser Kit Gun Orientation for 8 - 12 in. Stripe Operation ti6591a For 8 - 10 in. stripe, adjust line width, loosen set screws at (A) and loosen gun adjuster (B). Tilt guns in for desired line width and 8 - 10 in.
Page 6
Bead Dispenser Kit - Parts List Bead Dispenser Kit - Parts List Remove cap (13) and install second hose (12) and clamp (11) for 12-inch bead dispenser ti31503a Ref. Part Description Qty. Ref. Part Description Qty. 194682 . HOSE, beads 24Z726 KIT, bead system 403237...
Page 7
6-Inch Dispenser Assembly - Parts List 6-Inch Dispenser Assembly - Parts List ti6593a Ref. Part Description Qty. Ref. Part Description Qty. 198376 . CAP, end, bead dispenser 277067 DISPENSER ASSY KIT, beads (see 102598 . SCREW, cap, sch item 8, Bead Dispenser Kit Parts List) 115483 .
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.