Control Panel - Sony JJTRON ADN-8118 Operating Instructions Manual

Control Panel

1 INPUT A button
Selects the input signal from the equipment connected
to the INPUT A connectors. The button lights when it
is pressed.
2 SCREEN BRIGHT +/– buttons
Adjusts the brightness of the screen.
+ : to increase brightness
– : to decrease brightness
3 WIDESCREEN MODE button
Selects the wide screen mode, which allows you to
display a 4:3 aspect ratio picture in 16:9 aspect ratio.
Each time you press the button, the FULL, ZOOM or
STANDARD mode is selected. (ADN-8118 only)
For ADN-8126, the button does not function for the
wide screen mode.
4 POWER ON button
Press and hold the button for two seconds to turn on
the unit when it is in standby mode. The button lights
in green when the power is on.
INPUT INPUT
A
1
SCREEN BRIGHT
+
2
WIDESCREEN
3
MODE
POWER ON STANDBY
4
5 STANDBY button
Press and hold the button for two seconds to make the
unit enter standby mode. The button lights in red while
the unit is in standby mode.
6 INPUT B button
Selects the input signal from the equipment connected
to the INPUT B connectors when the BKJ-100
JJTRON Accessory Board is attached to the INPUT B
attachment part. The button lights when it is pressed.
Each time the button is pressed, VIDEO (video
signal), YUV (component signal) or RGB (RGB
signal) is selected.
B
6
–
5
7
(GB)