PIKO 35041 Quick Start Manual

7.2 Operation with the R/C speed controller 35008
The operation is simple. By pressing the buttons on the remote control, you can select
the direction of motion, speed level and, depending on the range of functions, switch the
accessory output and trigger an emergency stop.
1 x = Forward driving direction, speed level 1
2 x = Forward driving direction, speed level 2
If you are already driving forwards with the locomotive, you can use the button
increase the speed (speed levels). By pressing
1x = Recerse driving direction, speed level 1
2x = Recerse driving direction, speed level 2
If you are already reversing with the locomotive, you can use the button
speed (speed steps). Press the button
You can press the buttons briefly, which only changes one speed step at a time, or you can
keep the buttons pressed, which causes the speed to change continuously.
= Accessories on/off
(Permanent output at R/C speed controller 35008)
= Emergency stop
REGULATORY INFORMATION
FCC ID: 2ATRN-35041
FCC Information (USA):
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
PIKO Spielwaren GmbH
Lutherstr. 30
96515 Sonneberg
GERMANY
, you can decrease the speed.
to increase the
to reduce the speed.
35041
R/C Pocket Remote
to
1. General information
Thank you for purchasing the PIKO R/C system for radio operation of garden railway
models.
Please read this manual carefully in order to use all functions of this device. It is
essential that you observe the following safety and warning instructions to ensure
trouble-free and safe operation of your model.
2. Safety & warning instructions
The remote control system is designed and approved to be used exclusively for the
control of RC models. PIKO accepts no responsibility in the event of any other use.
Remote-controlled models are no toys and suitable for model railroaders aged 14 and
older. The construction and operation of such models requires special knowledge,
technical care, technical understanding and careful, safety-conscious behaviour.
Errors during installation or operation can cause considerable damage to property and
personal injury. We as manufacturer and seller have no means of monitoring the proper
operation of our products. Therefore we do not assume any liability.
Technical defects of an electrical or mechanical nature can lead to the unexpected
starting of a motor, which can seriously injure not only you! An operation of the
receiving system without activated transmitter can also lead to this effect.
Protect your remote control from dust, dirt and moisture. Do not expose the devices to
excessive heat, cold or vibration. The remote control operation may only be carried out
in the specified temperature range from -15°C to +55°C. The remote control may only
be operated in the specified temperature range from -15°C to +55°C. Avoid shock and
high pressure loads. Always check your remote control for damage to casings, cables
and connections.
3. Technical data
Transmitter (Pocket Remote)
Number of channels: 8
Frequency range:
Range: approx.
Power supply:
Dimensions: approx: 2.68'' x 1.42'' x 0.63'' (68 x 36 x 16 mm)
Weight: approx.
2.4 GHz
30 m
1x 3 V CR2025
30 g