NEC MultiSync LCD1510+ User Manual page 13

Installation
Connection to your Personal Computer (Macintosh)
With the Macintosh cable adapter, the MultiSync LCD
+ colour monitor is compatible with the Macintosh family of
LCD
1510V
computers. You will connect your MultiSync colour monitor one of
two ways to your Macintosh computer:
– On-board video port1
– NuBus/PCI/PDS display card
Both configurations should have the same style video connector. If you
are not sure which port is the monitor connector, please reference your
computer or display card manual.
To attach your MultiSync LCD monitor to your system, follow these
instructions:
1. Turn off the power to your MultiSync LCD monitor and
Macintosh.
2. If necessary, install the display card. For more information on
this installation, reference the display card manual.
3. Connect the MultiSync LCD
Macintosh cable adapter to the computer (Figure B.1). Attach
the 15-pin mini D-SUB end of the appropriate signal cable to
the MultiSync LCD
cable adapter (Figure B.1). Tighten all screws.
4. Connect the 15-pin mini D-SUB of the video signal cable and
the AC Adapter cable to the appropriate connectors on the back
of the monitor (Figure C.1). Place the AC adapter cable under
Clip A ( Figure C.1A).
NOTE: Incorrect cable connections may result in irregular operation,
damage display quality/components of LCD module and/or shorten the
module's life.
5. Connect one end of the power cord to the AC Adapter and the
other end to the power outlet (Figure D.1).
6. Turn on the monitor (Figure E.1) and the computer.
78134712
+ or MultiSync LCD
1510
+ or MultiSync LCD
1510
25
E - 11
+ /
1510
+
1510V
+ Macintosh
1510V
99/11/16, 3:44 PM