Troubleshooting/Support - NEC MultiSync LCD1510+ User Manual

E - 24

Troubleshooting/Support

Problem
No picture
Power Button
does not respond
Image persistence
78134712
Check These Items
- The signal cable should be completely connected to
the display card/computer.
- The display card should be completely seated in its
slot.
- Power button and computer power switch should be
in the ON position.
- Check to make sure that a supported mode has been
selected on the display card or system being used.
(Please consult display card or system manual to
change graphics mode.)
- Check the monitor and your display card with respect
to compatibility and recommended settings.
- Check the signal cable connector for bent or pushed-
in pins.
Unplug the power cord of the monitor from the AC
outlet to turn off and reset the monitor, or simultaneously
press the RESET and Power buttons.
Image persistence is when a "ghost" of an image
remains on the screen even after the monitor has been
turned off. Unlike CRT monitors, LCD monitors'
image persistence is not permanent. To alleviate image
persistence, turn the monitor off for as long as an image
was displayed. If an image was on the monitor for one
hour and a "ghost" of that image remains, the monitor
should be turned off for one hour to erase the image.
NOTE: As with all personal display devices, NEC
recommends using a screen saver at regular intervals
whenever the screen is idle.
38
Troubleshooting/Support
99/11/16, 3:45 PM