AirLive AC-1200R Setup Manual

1. INSTALLATION STEPS

Installation steps required for the AC-1200R before it can work properly in your network.
1. Install antennas into the AC-1200R
2. Connect ONR LAN port into the WAN port of the AC-1200R
3. Connect PC/Laptop into LAN port of AC-1200R or ONR LAN port if without AC-1200R.
4. Connect Power jack for to the power port for both AC-1200R and ONR
5. ON power for ONR and wait it finished boot (Power/PON/Internet light up) and follow by AC-
1200R.
6. To access AC-1200R .Then open the browser on your PC and type in "192.168.0.250" to reach the
web management
7. Please proceed to AC-1200R configuration.

2. AC-1200R Configuration

Important Before you start. Please note password and SSID are case sensitive.
The default IP address is: 192.168.0.250 Subnet Mask: 255.255.255.0
When using Web UI, the login as follow:
User name: admin
Password: airlive
The default radio mode for Radio 1 is 802.11ac/n
The default radio mode for Radio 2 is 802.11g/b/n
The default SSID for Radio 1 is: AirLive
The default SSID for Radio 2 is: AirLive 5G
The default wireless mode is : Dual Band Router Mode
After power on, please wait for 2 minutes for AC-1200R to finish boot up
Please remember to click on "Apply" for new settings to take effect

3. Prepare your PC

The AC-1200R can be managed remotely by a PC/Laptop through either wired or wireless
network. The default IP address of the AC-1200R is 192.168.0.250 with a subnet mask of
255.255.255.0 This means the IP address of the PC should be in the range of 192.168.0.1 to
192.168.0.253.
SETUP FOR ALIVE ROUTER AC-1200R