Preparation Before Operation - Mitsubishi Electric MSZ-HR25VF Operating Instructions Manual

N
AME OF EACH PART
Indoor unit
Front panel
Air fi lter
Air cleaning fi lter
(Silver-ionized
air purifi er fi lter,
option)
Horizontal vane
Air outlet
Spec name plate *1
Operation indicator lamp
Remote control receiving section
Emergency operation switch
Outdoor unit
Outdoor units may be different in appearance.
*1 The manufacturing year and month are indicated on the spec name plate.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or
turn the breaker on.
Installing the remote controller batteries
1.
Remove the back lid.
2.
Insert the negative
pole of AAA alkaline
batteries fi rst.
3.
Install the back lid.
Heat exchanger
Air inlet
Page 7
Air inlet (back and side)
Spec name plate *1
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
4.
Press RESET.
Remote controller
Battery replacement indicator
Page 4
Operation dis-
play section
OFF/ON
(stop/operate)
button
Temperature
buttons
Page 5
Operation
select button
Page 5
TIMER mode
select button
Page 7
RESET
button
Page 4
Only use the remote controller provided
with the unit.
Do not use other remote controllers.
If two or more indoor units are installed
in proximity to one another, an indoor
unit that is not intended to be operated
may respond to the remote controller.
Note:
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low.
In about 7 days after the indicator starts lights up, the remote controller stops
working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with ex-
pired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
Signal transmitting section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit
when the signal is
received.
ECONO COOL
button
Page 7
FAN speed
control button
Page 6
VANE control
Page 6
button
TIME set buttons
Page 7
Remote controller
When the remote controller is not used,
place it near this unit.
EN-4
EN