Preparation Before Operation - Mitsubishi Electric Mr. Slim MS-GL18VF Operating Instructions Manual

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART
Indoor unit
Front panel
Air fi lter
(Nano platinum fi lter)
Air cleaning fi lter
Air inlet
Fan
Air outlet
Fan guard
Horizontal vane
Display section
Operation indicator lamp
Emergency
operation switch
Remote control receiving section
Outdoor unit
Outdoor units may be different in appearance.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
1.
Remove the front lid.
3.
Install the front lid.
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
En-3
Heat exchanger
Fan guard
Vertical vane
Page 4
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
2.
Insert the negative pole
of AAA alkaline batteries
fi rst.
www.ttair.co.th | Tel : 02-385-0728 | E-mail : sales@ttair.co.th | LINE ID : @ttair
Remote controller
Operation
display section
ON/OFF
(operate/stop)
button
ECONO COOL
button
Page 5
POWERFUL
COOL button
Page 5
Operation
select button
Page 4
Only use the remote controller provided with the
unit.
Do not use other remote controllers.
If two or more indoor units are installed in proxim-
ity to one another, an indoor unit that is not in-
tended to be operated may respond to the remote
controller.
4.
Press RESET.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit
when the signal is
received.
Temperature
buttons
Page 4
FAN speed
control button
Page 5
VANE control
button
Page 5
TIME set button
Page 6
TIMER mode
select button
Page 6
RESET button
Page 3
Remote controller
holder
• Install the remote control-
ler holder in a place where
the signal can be received
by the indoor unit.