Wiring Diagram Of Optex Os-12C Module For Two Infrared Beams - Nabco GYRO TECH GT-1175 Installation Manual

U30 Electrical Installation Manual
D.2.2 Wiring Diagram of Optex OS-12C Module for Two Infrared Beams
Wiring Diagram for Two Holding Beams using Optex OS-12C
Controller on a GT-1175 with U30 control.
Infrared Beams (Activation-Hold Open)
The infrared beam assembly is a factory-installed unit
consisting of an emitter, detector and control box. They
are flush mounted in door frames and/or jamb tubes,
facing each other along the threshold. A pulsed, infrared
light beam is continuously transmitted across the door
opening. Interruption of the beam will switch the White
holding beam input wire to Red (Common). This will
cause the system to re-activate and hold open until the
interruption is cleared.
Wiring Diagram for Two Breakout Beams using Optex OS-12C
Beams on a GT-1175 with U30 control.
Infrared Beam (Breakout—Power Interrupt)
The infrared beam assembly is a factory-installed unit
consisting of an emitter, detector and control box. The
emitter and detector are flush mounted in door frames
and/or jamb tubes, facing each other. A pulsed, infrared
light beam is continuously transmitted across the door
opening. Interruption of the beam by breaking out a door
panel will interrupt the Blue wire power down loop. This
will cause the system to stop operating until the door
panel is repositioned and latched.
Page 14
Plastic Conductor
Jacket color
Plastic Conductor
Jacket color
www.NabcoEntrances.com
Term # & Color
Connect
Each Terminal
the Same
RCVR 1
Braided
Blue
Shield
EMTR 2
Gray
Yellow
Terminal #6
Optex Controller
PT. NO. 14-9710-03
Optex OS-12C
Terminal #1
Power
Power
Signal
Signal
Term # & Color
Connect
Each Terminal
the Same
RCVR 1
Braided
Blue
Shield
EMTR 2
Gray
Yellow
Terminal #6
Optex Controller
PT. NO. 14-9710-03
Terminal #1
Power
Power
Signal
Signal
EMTR 1
Gray
RCVR 2
Blue
Terminal #13
Controller
Terminal #5
EMTR 1
Gray
RCVR 2
Blue
Terminal #13
Optex OS-12C
Controller
Terminal #5
04-24-08