Warranty Period; Registration For Warranty - Sanden GAUS-160FQS Owner's Manual

cont.
7. Where the unit fails to operate or fails as a result of ice formation in the piping to or
from the Heat Pump Water Heater System.
8. Where the Heat Pump Water Heater System is located in a position that does not comply
with the Heat Pump Water Heater System installation instructions or relevant statutory
requirements, causing the need for major dismantling or removal of cupboards,
doors or walls, or use of special equipment to bring the Heat Pump Water Heater
System to floor or ground level or to a serviceable position.
9. Repair and/or replacement of the Heat Pump Water Heater System due to scale formation
in the waterways or the effects of either corrosive water or water with a high chloride or
low PH level when the water heater has been connected to a scaling or corrosive water
supply or a water supply with a high chloride or low PH level as outlined in the Owner's
Manual and Installation Manual.
10．Warranty service is provided to the original owner of the equipment only.
Subject to any statutory provisions to the contrary, this warranty excludes any and all claims
for damage to furniture, carpets, walls, foundations or any other consequential loss either
directly or indirectly due to leakage from the Heat Pump Water Heater System, or due to
leakage from fittings and/or pipe work of metal, plastic or other materials caused by water
temperature, poor workmanship or other modes of failure.

Warranty Period

Subject to the Warranty Conditions and Exclusions stated above, your Sanden Heat
Pump Water Heater System is warranted in a Residential application as follows:
Heat pump unit – Sanden warrants all parts labour on the SANDEN water heater system
Tank unit –
In a Commercial or Industrial application the warranty period on both Heat
Pump unit and Tank is reduced to 1 (One) year only with no Labour warranty.
Warranty terms and conditions are subject to change without notice. Please refer to our
website www.sanden-hot-water.com.au for the latest updated Warranty information.

Registration for warranty

In order to register your system for warranty purposes, please visit our website www.sanden-hot-
water.com.au, locate the Warranty Registration page and complete the details of your purchase
for a period of 6 (Six) years from date of installation.
Labour costs are paid directly to the servicing contractor per the
payment cost schedule published by Sanden and revised from
time to time at Sanden's requirement.
Sanden warrants that the tank will be free from defects for 10
years at 100% replacement, and for a further 5 years under a
pro-rated scale, culminating in warranty end after Fifteen years
from date of installation
Sanden Heat Pump – Owner's Manual
Page 19 of 20