Summary of Contents for Gasmate Inferno FHIN100 Series
Page 1
Flame Heater FEATURES: FHIN100 SERIES • The ideal solution for FOR YOUR SAFETY extending the season of If you smell gas: outdoor entertaining 1.Shut off the gas to the • Direct ignition appliance. • Maximum output 36MJ/h 2. Extinguish any open flame. •...
INSTALLATION, OPERATION & MAINTENANcE INSTRUcTIONS INSTALLATION 3. Proper clearance from combustible materials Important Safety Rules must be maintained at all times. The minimum clearances are as follows: This appliance must only be used in a well ventilated area. Minimum Clearance from Combustibles: 1.
Page 3
e. Any cleaning agent used on the appliance Any modification to the heater not described in should be of a non-combustible and non- the installation instructions may compromise the corrosive nature. safety of this appliance. Special concern is as follows: DO NOT bypass thermocouple safety;...
PARTS & cONTENTS Chimney cover Weather resistant heat reflector prevents water from entering the combustion zone and reflects heat down. Safety guard protects the full height of the heat exchanger tube. Heat exchange tube has a large heat-radiating surface. Gas control with electronic igniter is centrally positioned for easy access.
Page 5
ASSEMBLY INSTRUcTIONS Remove any transit protection material. STEP 1 To assemble unit, partially open gas chamber door. Carefully lift heat reflector until entire heat exchange tube is exposed. STEP 2 After heat exchange tube is fully extended, rotate counter-clockwise until it stops.
Page 6
STEP 3 Fully open gas chamber door. Remove knob from door and place on control stem. STEP 4 Locate (2) holes to lock heat exchange tube in place. Secure with (2) included wing screws. 1-Thumb Screws M6x12 1 PC...
Page 7
STEP 5 Locate automatic igniter under control panel. Unscrew igniter cap and insert a 1.5V AA battery (not included). AA 1.5V Battery (not included) STEP 6 Installing the Separation Panel a. Holding the panel on both sides with the bent tabs facing downwards, flex the panel sides upwards forming the panel into a concave curve.
Page 8
OUTDOOR FLAME HEATER - FOR OUTDOOR USE ONLY Minimum clearance from combustible Surfaces*: *Combustible materials are considered to be wood, compressed paper, plant fibres, plastic or other materials that are capable of being ignited and burned.
LIGHTING INSTRUcTIONS TEST FIRING HEATER Test fire heater, following the lighting instructions. Step 1 Leak test all gas connections with soapy water. Ensure that the control knob is off. Slowly open Soap bubbles indicate gas leakage. DO NOT use a the gas cylinder valve.
In the case of balconies, at least 20% of the total wall area shall be and remain open and unrestricted. The following figures are diagrammatical representations of outdoor areas. Rectangular areas have been used in these figures - the same principles apply to any other shaped area. Gasmate is a registered trademark of: Sitro Group Australia Pty Ltd www.gasmate.com.au...