Advertisement
Accessory Shield User Manual
7)
Configure XBee-A and XBee-B according to the processes described above.
When finished, start two X-CTU tools, and select different COM interfaces in
the option PC Settings to control Group A and Group B respectively.
8)
Input the data to be transmitted in the X-CTU Terminal of XBee-A, then, you
can find that the inputted data will be sent to XBee-B automatically, and
displayed in the X-CTU Terminal of XBee-B. In the X-CTU, data in blue is the
data to be sent, and data in red is the received data.
9)
The figure above shows the normal operating state of XBee module. You can
use XBee modules to perform wireless communication in Arduino projects. It is
easy to done, transmitting the data to be sent to XBee-A via the serial port of
Arduino development board-A, then, receiving the data by XBee-B and reading
it out on PC via the serial port of Arduino development board-B.
Notices: In this operation, you should set the jumpers of Accessory
Shield:
Connect TXD to RX;
Connect RXD to TX.
th
V1.1.6, March 10
2015
e) Select the option ZIBGEE ROUTER/END DEVICE AT under
the pull-down menu Function Set;
f)
Click the button Show Defaults;
a) Select the option PAN ID and modify its parameter to 1234;
b) Select the option Channel Verification(JV), and modify its
parameter to 1-ENABLED;
c) Click the button Write to finish the setting of XBee-B.
Waveshare
18
Advertisement
