Advertisement
Accessory Shield User Manual
2.1.2 Program compiling and uploading
1)
Switch the BOOT mode of UNO PLUS development board to OFF, and set
VCC to 5V;
2)
Connect the Accessory Shield module to the UNO PLUS development board,
and then the development board to your PC via a USB cable. You can see the
power light on the module lights up when the module is working properly.
3)
This document presents the method of program compiling and uploading with
the Demo provided by Arduino IDE. Click File -> Example -> 01.Basics -> Blink,
to open the Demo.
th
V1.1.6, March 10
2015
Waveshare
5
Advertisement
