Advertisement
Accessory Shield User Manual
should be configured correctly. You can configure the XBee module by X-CTU
tool, or by AT commands via a serial terminal. This document will introduce how
to use X-CUT tool to configure XBee merely.
5)
Click the button Test/Query to test whether the software is connected to the
XBee module properly. Normally, we will see the dialog box popped out, as
figure shows below. If it cannot communicate with the XBee module but all the
communication parameters are set correctly, please check the USB connection
and the jumper settings on the Arduino development board and the XBee
module.
6)
After a successful test, select the option Modem Configuration. Then, click
the button Read to get the current parameters of the XBee module.
th
V1.1.6, March 10
2015
Waveshare
15
Advertisement
