Appendix Two：common Trouble Analysis And Solution - YANYU ITX-K100 User Manual

ITX-K100
Base on Intel® Bay Trail platform Mini-ITX motherboard
：C
A T
PPENDIX WO
Common faults
After the power on
is not boot
VGA not display
BIOS Setup can not
be saved
Could not find the
boot device
Into the blue screen
or crash in the
process
Enter the operating
system slowly
OMMON TROUBLE ANALYSIS AND SOLUTION
1.Make sure the power cable is connected properly
2. Please confirm whether the power supply to meet the
requirements of the motherboard
3. Try to re plug the memory
4. Try to change the memory
5. Try to clear the CMOS
6. Please confirm whether there is an external card, remove the
card is normal or not
1 To see whether the display is open
2 Check that the power cord is properly connected to the monitor
and system unit
3 Check whether the display cable is properly connected to the
system unit and the display
4 To see whether the display brightness control is set to the dark
state, can improve brightness through the brightness control.
5 Display in the "power" mode, press any key on the keyboard
can be
1. Please confirm whether the CMOS battery voltage is lower than
2.8V, if less than 2.8V, please replace the new battery, re set to
save
2. BIOS settings are not correct, according to the boot screen
prompt button (DEL), adjust the time and date in the Setup BIOS
1. Please confirm the hard drive power cord, the data line is
connected to normal
2.Please confirm whether the hard disk has physical damage
3.Please confirm whether the operating system is normally
installed on the hard disk
1. Please confirm whether the memory card and the card is loose
2. Try to remove the newly installed hardware, uninstall the driver
or software
3. Try to replace the memory
1. Try to use third party software to check whether the hard disk
has bad sectors
- 56 -
Checkpoint