Jumper Function Settings; Cmos Clear/ Hold Jumper Settings(Jbat1) - YANYU ITX-K100 User Manual

ITX-K100
Base on Intel® Bay Trail platform Mini-ITX motherboard
2.5 J F
UMPER UNCTION
Please refer to following instructions to do jumper settings before installing the
motherboard.
How to identify the 1st pin of all jumpers and interfaces, Please observe the
Remark:
word mark on the side of the plug socket, which will be a "1" or bold line or triangular
symbol; And please look at the back of PCB, each with a square shape will be the
PIN 1; and all the jumpers'PIN1 have a white arrow on the side.
2.5.1 CMOS C
LEAR
CMOS is powered by the onboard button cells. Clear CMOS may lead to
permanent elimination of previous system settings and make the system back to the
original settings (factory default ).
Steps: (1) Shut down the computer and disconnect power supply.
(2) Make the jumper cap "JBAT1" Pin2 and 3 shorted for 5~6 seconds, and
make it back to default setting with Pin 1-2 connected ;
(3) Start up computer and press "Delete" to enter BIOS setup.
(4)Press"F9"----"Enter"then reload optimal defaults.
(5) Press "F10 ",Save and Exit.
S
ETTINGS
/ H J
OLD UMPER
- 14 -
S (JBAT1)
ETTINGS