Mechanical Installation; Removing The Terminal Covers - Control Techniques Commander SK2202 Getting Started Manual

Safety Product Mechanical
Information Information Installation
3

Mechanical Installation

The drive is intended to be mounted in an enclosure which prevents access except by trained and authorised personnel, and which
prevents the ingress of contamination. It is designed for use in an environment classified as pollution degree 2 in accordance with IEC
60664-1. This means that only dry, non-conducting contamination is acceptable.
WARNING
3.1

Removing the terminal covers

To remove a terminal cover, undo the screw and lift the terminal cover off as shown. When replacing the terminal covers, the screws should be
tightened with a maximum torque of 0.8Nm (0.6 lb ft) for the control terminal cover and 1Nm (0.7 Ib ft) for the other covers.
Figure 3-1 Removing the control stage terminal cover
Figure 3-2 Removing the size 2 power stage terminal cover Figure 3-3 Removing the size 3 power stage terminal cover
Pozi Pz2
Figure 3-4 Removing the size 4 power stage terminal cover
16
Electrical Keypad and
Parameters
Installation Display
Pozi Pz1
Pozi Pz2
www.controltechniques.com
Quick Start
Diagnostics
Commissioning
Pozi Pz2
Commander SK Size 2 to 6 Getting Started Guide
UL Listing
Options Parameter List
Information
Issue Number: 2