Bridge Configuration
The bridge configuration section includes information
on the following:
Source Routing Transparent (SRT)
Source Route (SR)
Transparent (TP)
Spanning Tree Fields
Setting Source Routing Transparent (VT100)
NOTE:This bridge setting requires that you reset the
switch. Refer to "Resetting the Switch 2000 TR in
Chapter 3 for instructions.
Log on to the Switch 2000 TR.
1
Select Switch Management from the Main Menu.
2
Press [Space Bar] and select *Bridge*.
3
Select SETUP. The TR Bridge Setup screen appears.
4
Figure 4-4 TR Bridge Setup Screen
Select OK.
5
Select *SRT*. Press [Space Bar] to change.
6
Press [Return].
7
Select *IBM*, *802.1d*, or *disabled* in the Span-
8
ning Tree Support field. A BPDU value is automatically
assigned:
802.1d Spanning Tree—80-01-43-00-00-00
IBM Spanning Tree—C0-00-00-00-01-00
Assign a Bridge Number. Enter in Hex. Choose from 0
9
to f.
Select OK.
10
From the Main Menu, press [Space Bar] until *Port*
11
appears. Select the proper unit and port ID to config-
ure.
Select SETUP. The TR Port Setup screen appears. See
12
Figure 4-5.
Figure 4-5 TR Port Setup Screen
Bridge Configuration
4-3