Vt100 Management Interface; Via The Serial Port; Via An Ip Network Connection - 3Com TR User Manual

3-2 C 3: S
HAPTER ETTING
Table 3-1 Switch 2000 TR Management Options
Access mechanism Allows you to. . .
Serial Port Establish an
out-of-band connec-
tion to the VT100 con-
sole.
IP Establish in-band
connection to the
VT100 console
SNMP Manage devices using
SNMP network man-
agement application
LCD Set basic parameter,
view port status, and
set Unit ID

VT100 Management Interface

The menu-driven interface for the Switch 2000 TR is
known as the VT100 interface or Local Management
interface. Using a simple series of menus, the VT100
interface provides access to switch functions, includ-
ing port, stack, unit, bridge, switch, and workgroup
settings and statistics; communication parameters,
and security levels for individual users. Refer to "The
VT100 Console" for more information.
You establish VT100 management communications
with the Switch 2000 TR via the serial port or an IP
Network connection as explained next.

Via the Serial Port

Access the management interface via a VT100 termi-
nal or using VT100 terminal emulation software. You
can connect directly to the Switch 2000 TR using the
U M
P FOR ANAGEMENT
Using . . .
VT100 Console
Telnet on TCP/IP
protocol stack
SNMP on TCP/IP
protocol stack
Front panel
display
serial port or via a modem connection. This method is
especially useful for initial setup and configuration or
if the device is not reachable via network manage-
ment applications.
This method allows you to manage the Switch 2000
TR when:
You configure and initialize the system.
The LAN is unable to provide reliable service.
The network manager does not have direct LAN
connection.
The network manager software does not support
SNMP.
When a connection has been established, the main
Switch 2000 TR banner appears and you can log on.

Via an IP Network Connection

Access the management interface via a Telnet utility
over a network running TCP/IP. The console interface
is the same as that of the interface for the serial port.
The Telnet application requires a VT100 terminal emu-
lation application interface.
Before you can start a Telnet session, you must set up
the IP parameters. To open a Telnet session, you must
specify the IP address of the device you want to man-
age. Up to three Telnet sessions can exist simulta-
neously.
When a connection has been established, the main
Switch 2000 TR banner appears and you can log on.