Led Description - Fujitsu MB2146-450-E Setup Manual

2.5 LED Description

First, when USB cable is plugged to PC, check whether the Power LED turns green or not.
Refer to Figure 2-7.
Second, plug IDC10 cable to the EV-board (target MCU board), then turn on EV-board. After
that, check whether the Power LED on the BGMA turns orange or not. Refer to Figure 2-8.
EV BOARD MB2146-450-E V1.3
Chapter 2 BGMA Manual
Figure 2-7: BGMA Power LED (1)
5V Power
through
IDC
Cable
Figure 2-8: BGMA Power LED (2)
MCU-AN-500072-E-13 – Page 11
Orange