Siemens M20 Terminal Technical Description page 69

Siemens Information and Communication Products
AT+COLP Connected line identification presentation
Test command Response
+COLP: (list of supported <n>s) OK
AT+COLP=?
Parameter
see set command
Read command Response
AT+COLP? +COLP: <n>,<m> OK
Parameter
see set command
Set command TA enables or disables the presentation of the COL (connected line) at the TE at a mobile origina-
AT+COLP=[<n>]
ting call. It has no effect on the execution of the supplementary service COLR in the network.
Intermediate result code is returned from TA to TE before any +CR or V.25ter [5] responses. It is
manufacturer-specific if this response is used when normal voice call is set up.
OK
Parameter
<n>
<m>
Intermediate result code
When enabled (and called subscriber allows), an intermediate result code is returned before any
+CR or V.25ter responses:
+COLP:<number>,<type>[,<subaddr>,<satype> [,<alpha>]]
Parameter
<number>
<type>
<subaddr> string type subaddress of format specified by <satype>
<satype>
<alpha>
Reference Note
GSM 07.07 Feature not available at some networks.
Version 8 dated 15.03.00
(parameter sets/shows the result code presentation status in the TA):
0 disable
1 enable
(parameter shows the subscriber COLP service status in the network):
0 COLP not provisioned
1 COLP provisioned
2 unknown (e.g. no network, etc.)
string type phone number of format specified by <type>
type of address octet in integer format; 145 when dialling string includes
international access code character "+", otherwise 129
type of subaddress octet in integer format (refer GSM 04.08 [8]
subclause 10.5.4.8)
optional string type alphanumeric representation of <number>
corresponding to the entry found in phonebook
AT command interface
A
69