Kohler SINGULIER 8161A Installation Instructions

Bath tapware, wall mount bath spout

Enlarged version

BATH TAPWARE

SINGULIER

INSTALLATION INSTRUCTIONS

Wall Mount Bath Spout

Wall Mount Bath Spout: 8161A

BEFORE YOU BEGIN

All information is based on the latest product information available at the time of publication. Kohler Co.

reserves the right to make changes in product characteristics, packaging, or availability at any time without

notice.

Please leave these instructions for the consumer. They contain important information.

NOTES:

1. Flush the water supply pipes thoroughly to remove any debris.

2. An in line water filter must be used with this product.

3. Inspect the supply pipes for damage. Replace as necessary.

4. Observe local plumbing codes.

5. Recommended working pressure: 100KPa to 500KPa.

6. Maximum working pressure: 800KPa.

7. All installations should comply with the relevant requirements of AS/NZS 3500.

3.8

158

185

Fringe Of Bath

8161A

15/10/12

1142969-AN2-A

Table of Contents

Do you have a question about the SINGULIER 8161A and is the answer not in the manual?

Page 1 Wall Mount Bath Spout: 8161A BEFORE YOU BEGIN All information is based on the latest product information available at the time of publication. Kohler Co. reserves the right to make changes in product characteristics, packaging, or availability at any time without notice.
Page 2 BATH TAPWARE INSTALLATION - Spout SINGULIER 1.) This spout is designed to be fitted onto a G1/2" male fitting(1) SPARE PARTS O32 Max Wall Mount Bath Spout that protrudes out from the finished wall minimum of 15mm. The wall hole is to be no bigger than 32mm in diameter. 2.) Apply tape or thread sealant to the G 1/2"...