Table of Contents
Advertisement
Section 4: Operating Instructions
4-1. Power Up Projector
Read the Important Safeguards before operating the MP8760 projector. After all cable connections have been
completed, the projector can be powered up. During operation, keep the exhaust and intake air vents clear of
obstructions to allow proper cooling.
1
1.
Press the Main Power switch
2.
Press the Standby button
and grows brighter on the screen.
3.
Check all ventilation slots
4.
Adjust the Focus
5.
Press the Foot Release button
6.
Power up your computer and video source(s).
3M IPC 2000
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
!
Caution
Allow a projector that has been stored in a cold place to warm up to room
temperature before applying power.
3
Figure 4-1. Power Up Projector
(1)
to ON. A red LED indicator will illuminate to indicate there is power.
(2)
to illuminate the lamp. A red LED indicator will turn green as an image appears
(3)
and clear away all obstructions.
Ventilation vents are located on the top and back of the projector. Do not
block airflow by placing objects on top of the projector.
(4)
(5)
and Zoom
for best image.
(6)
to release the height adjustment foot
In most cases, the projector will automatically adjust to the graphic mode
of your computer by selecting a pre-programmed setting.
3M
Multimedia Projector MP8760
5
+
—
6
7
! ! ! ! Note
(7)
.
! ! ! ! Note
2
4
+
—
EPS-18A
7
Advertisement
Table of Contents
