Table of Contents
Advertisement
Humming noise.
Slowly passing
horizontal bars.
The factory default settings of the projector can be restored by pressing Enter and Mute
simultaneously on the control panel when switching on the main power switch of the
projector and pressing the Standby button afterwards.
The projector will start immediately and the message "Parameter factory settings restored"
displayed in the starting screen will indicate the default settings are reset.
7-2. Service Information
For product information, product assistance, service information, or to order accessories or spare parts, please call:
In U.S. or Canada: 1-800-328-1371
In other locations, contact your local 3M Sales office.
22
T H E T R U S T E D S O U R C E F O R P R O J E C T O R L A M P S A N D A C C E S S O R I E S
•
•
Signal sources are
Locate the source of disturbance. Disconnect the sources
connected to different
one after another from the projector. Connect all sources to a
power sources.
common power source.
•
•
VCR connected to
Remove antenna connection from VCR. If the disturbance
aerial system and to
disappears, use a by-pass filter (isolating transformer) to
projector.
connect the antenna to the VCR.
•
•
Bad signal.
Try different input source.
! ! ! ! Note
3M
Multimedia Projector MP8760
3M IPC 2000
Advertisement
Table of Contents
