Functional Description - Makita DUT130 Instruction Manual

8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
10. The contained lithium-ion batteries are subject
to the Dangerous Goods Legislation
requirements.
For commercial
by third
agents, special
on packaging and labeling must be
observed. For preparation of the item being
shipped, consulting
for hazardous material
required. Please
possibly more
regulations.
Tape or mask off open contacts and pack up the
battery in
manner that
move around in the packaging.
11. Follow your local regulations relating to
disposal of battery.
12. Use the batteries only with the products
specified by Makita. Installing the batteries to
non-compliant products
in a
heat, explosion, or
of electrolyte.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been
in
bursting
personal
damage.
void
warranty
tool
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery
cartridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room
temperature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge if you do not use
it for a long period (more than six months).
transports e.g.
parties, forwarding
requirement
an expert
is
also observe
detailed national
such a
it cannot
may result
fire, excessive
leak
altered, may result
the battery
causing fires,
injury and
It will also
the Makita
for the Makita
and charger.
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery
cartridge firmly when installing or removing
battery cartridge.
the
battery
cause
off
result
the
cartridge
personal
CAUTION:
Do not use this tool with the
battery adapter.
the
the
cover
and
with
may
Open the
pressing the
battery cover.
►
Fig.1:
To remove
slide it
while sliding the button on the front of the cartridge. ►
Fig.2: 1. Red indicator 2. Button 3.
cartridge
To install
align the
battery cartridge
in the
it into
all the
locks in
little click.
see the
the upper
button, it
completely.
After installing
close the
9 ENGLISH
Failure to
tool and
cartridge firmly
them to
your hands
in damage
tool and
and a
injury.
If you
battery adapter
tool, the
cannot be
using the
battery cover
cause an
battery cover
button on
1. Button 2. Battery
the battery
from the
the battery
tongue on
with the
housing and
place. Insert
way until
place with
If you
red indicator
side of
is not
the battery
battery cover
hold
the
may
slip
and
to
battery
connect
to
battery
closed,
tool
opened
injury.
while
the
cover
cartridge,
tool
Battery
cartridge,
the
groove
slip
it
it
a
can
on
the
locked
cartridge,
securely.